INDASA E Série Manuel D'instructions page 30

Temperature Overheat System
The Sander has the ability to monitor temperature of the internal electronic systems, and
can shut the tool down when temperature reach damaging levels. During periods that
result in high internal temperature, the Sander will shut down if the temperature reaches
a damaging level. The Sander will not be able to be restarted until the internal tempera-
ture cools to a level safe for the electronic systems. Cooling time depends on local condi-
tions. An initial waiting period of 5 minutes is recommended. Repeated overheating will
result in longer cool down times.
ATTACHING DISC PADS
1. Secure the Spindle with the flat wrench provi-
ded with the tool, and screw the Disc pad on. Ti-
ghten to firm hand-tightness. Do not over tighten.
2. To remove the Disc Pad, insert the flat wrench
between the Disc Pad and shroud. Secure the
Spindle with the flat wrench and unscrew the Disc
pad. - see figure 5.
Figure 5
CLEANING
1. Periodically blow out all air passages and area above Disk Pad and under shroud with dry compressed air. All plastic
parts should be cleaned with a soft damp cloth. NEVER use solvents to clean plastic parts.
2. Wear safety glasses while using compressed air.
HEALTH AND SAFETY INFORMATION
RoHS CompliantThis product and the associated component parts are "RoHs Compliant" and do not contain any of the sub
stances in excess of the maximum concentration values in EU Directive 2002/95/EC, as amended by Commission Decision
2005/618/EC and other amendments issued as of the date code marked on the product.
Waste Electrical & Electronic Equipment (WEEE) Compliant
• Do not dispose of electrical appliances as unsorted municipal waste, use separate collection facilities.
• Contact your local government for information regarding the collection systems available.
• If electrical appliances are disposed of in landfills or dumps, hazardous substances can leak into the groundwater and
get into the food chain, damaging your health and well-being.
• When replacing old appliances with new ones, the retailer is legally obligated to take back your old appliance for
disposal at least for free of charge
Federal Communications Commission (FCC) Compliance Statement
IMPORTANT NOTE : This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to Part 15 of the FCC rules.
These limits are designed to provide a reasonable protection against harmful interference when the equipment is oper-
ated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instruction manual, may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be
required to correct the interference at his own expense.
NOTICE: Changes or modifications not expressly approved by the party responsible for compliance could void the user's
authority to operate the equipment.
Industry Canada Compliance Statement
This Class A digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe A est conforme à la norme NMB-003 du Canada.
30