INDASA E Série Manuel D'instructions page 23

a. Do not force the power tool. Use the correct power tool for your application. The
correct power tool will do the job better and safer at the rate for which it was designed.
b. Do not use the power tool if the switch does not turn it on and off. Any power tool that
cannot be controlled with the switch is dangerous and must be repaired.
c. Disconnect the plug from the power source and/or the battery pack form the pow-
er tool before making any adjustments, changing accessories, or storing power tools.
Such preventive safety measures reduce the risk of starting the power tool accidentally.
d. Store idle power tools out of reach of children and do not allow persons unfamiliar
with the power tool or these instructions to operate the power tool. Power tools are
dangerous in the hands of untrained users.
e. Maintain power tools. Check for misalignment or binding of moving parts, breakage
of parts and any other condition that may affect the power tool's operation. If damaged,
have the power tool repaired before use. Many accidents are caused by poorly main-
tained power tools.
f. Keep cutting tools sharp and clean. Properly maintained cutting tools with sharp
cutting edges are less likely to bind and are easier to control.
g. Use the power tool, accessories and tool bits, etc. in accordance with these instruc-
tions, taking into account the working conditions and the work
h. to be performed. Use of the power tool for operations different from those intended
could result in a hazardous situation.
5) Service
a. Have your power tool serviced by a qualified repair person using only identical re-
placement parts. This will ensure that the safety of the power tool is maintained.
To reduce the risks associated with impact from abrasive product, disc pad, or tool
breakup, sharp edges,hazardous downforce, rupture, vibration and noise :
• Only personnel who are properly trained should be allowed to service this tool.
• If you notice any abnormal noise or vibration when operating the tool, immediately
discontinue its use and inspect for worn or damaged
components. Correct or replace the suspect component. If abnormal noise or vibration
still exists, return the tool to INDASA for repair or
replacement. Refer to warranty instructions.
• Prior to use, inspect abrasive product and accessories for possible damage. If dam-
aged, replace with new abrasive product and
accessories available from INDASA.
• Only use accessories supplied or recommended by INDASA.
To reduce the risks associated with vibration :
• If any physical hand/wrist discomfort is experienced, work should be stopped prompt-
ELECTRIC RANDOM ORBITAL SANDER
Warning
127 mm (5 in.) and 152 mm (6 in.)
23