Publicité
Les langues disponibles
Les langues disponibles
Removing the shipping bolts
Before using the washing machine, you must remove all of the shipping bolts from the back of the unit. To remove the
bolts:
1. Loosen all bolts with the wrench before removing them.
2. Take each bolt head and pull it through the wide part of the hole.
Repeat for each bolt.
3. Fill the holes with the supplied plastic covers.
4. Keep the shipping bolts for future use.
Connecting the water supply hose
The water supply hose must be connected to the washing machine at one end and to the water faucet at the other.
Do not stretch the water supply hose. If the hose is too short and you do not wish to move the water faucet, replace the
hose with a longer, high pressure hose.
To connect the water supply hose:
1. Take the L-shaped arm fitting for the cold water supply hose and
connect to the cold water supply intake on the back of the machine.
Tighten by hand.
2. Connect the other end of the cold water supply hose to your sink's cold
water faucet and tighten it by hand.
If necessary, you can reposition the water supply hose at the washing
machine end by loosening the fitting, rotating the hose, and
retightening the fitting.
Positioning the drain hose
The end of the drain hose may be positioned in three ways:
Over the edge of a sink
The drain hose must be placed at a height of between 60 and 90 cm. To
keep the drain hose spout bent, use the supplied plastic hose guide. Secure
the guide to the wall with a hook or to the faucet with a piece of string to
prevent the drain hose from moving.
ln a sink drain pipe branch
The drain pipe branch must be above the sink siphon so that the end of the
hose is at least 60 cm above the ground.
ln a drain pipe
Samsung recommends that you use a 65 cm high vertical pipe; it must be
no shorter than 60 cm and no longer than 90 cm.
Installing the Washing Machine
4
Publicité
