De Dietrich DHG7501X Instructions D'utilisation Et Avis De Montage page 17

TIMING
As a result of the new EU65 "Energy label" and
EU66 " Ecodesign" regulations issued by the Eu-
ropean Commission, which came into force as
from January 1 , 2015 , our products have been
st
adapted to comply with these new requirements.
All of the models complying with the energy label
requirements, are equipped with new electronics
including a timer device for suction speeds con-
trol, when the air capacity exceeds 650m³/h.
Internal motor models, with maximum air capacity
higher than 650m³/h, are equipped with a timer de-
vice that automatically switches the suction speed
from 4 to 3 speed, after 5 minutes operation.
th rd
External motor models are equipped with remote
motors that , as for internal motor versions, inclu-
de a timer device that switches down the suction
speed when it exceeds 650 mᵌ/h. (See External
Motors Instructions).
Remote motors, whose air capacity exceeds
650m³/h at both 4 and 3
th
following by default timer control functions: The
suction speed is automatically switched from 4
2 speed, after 6 minutes operation.
nd
If the appliance is working at 3
matically switched to 2
operation. Operation speeds can also be changed
during operation.
The energy consumption of the appliance in stand
– by mode is lower than 0.5W.
speed , will have the
rd
speed, it is auto-
rd
speed, after 7 minutes
nd
MAINTENANCE
* An accurate maintenance guarantees good fun-
ctioning and long-lasting performance.
* Particular care is due to the grease filter panel. It
can be removed by pushing its special handle to-
ward the back-side of the cooker hood and turning
the filter downwards so to unfasten it from its slot.
To insert the filter just perform the opposite ope-
ration.
After 30 hours working, the push button control
panel will signal the saturation of the grease filter
by lighting all the buttons. Press the timer button
to reset .
The grease filter needs cleaning by regular hand-
washing or in dishwashers every two months at
to
th
least or depending on its use.
* In case the appliance is used in its filtering ver-
sion, the active coal filter needs to be periodically
replaced. The coal filter can be removed by remo-
ving the grease filter first, and by pulling its special
plastic tongue until it is unfastened from its slot.
Re-insert the coal filter by operating in the opposi-
te way. The coal filter needs replacing depending
on the use, but however every six months at least.
* To clean the appliance itself tepid water and neu-
tral detergent are recommended, while abrasive
products should be avoided. For steel appliances
specialized detergents are recommended (please
follow the instructions indicated o the product itself
to obtain the desired results).
The lighting system cannot be replaced by the
user, contact Customer Service in case of malfun-
ction.
* If the supply cord is damaged, it must be repla-
ced by the manufacturer or its sevice agent or a si-
milarly qualified person in order to avoid a hazard.
17