Publicité
Les langues disponibles
Les langues disponibles
1. Insert axle through holes in wheel support.
2. Slide then spacer onto axle.
3. Slide wheel onto axle and hold in place with
the axle nuts. (See Figure 2).
Wheel Support Frame
Tire
Axle Nut
Figure 2
4. Place heater on wheel support frame and line
up holes on the fuel tank lip.
5. Attach front handle with (4) long screws
(50 mm) and (4) nuts through the second and
third hole from the front on both sides of the
tank lip and wheel support frame and tighten
firmly.
6. Insert (2) short screws (30 mm) through the
first hole the front of in the tank lip and tighten
firmly. Make certain all (6) screws are secure.
7. Attach rear handle with (4) long screws (50
mm) and (4) nuts through the first and second
hole from the rear on both sides of the tank
lip and wheel support frame and tighten
firmly.
8. Attach front guard with the included
hardware.
© 2015, Pinnacle Products International, Inc.
NEVER LEAVE HEATER UNATTENDED WHILE BURNING OR
WHILE CONNECTED TO A POWER SOURCE
Assembly Instructions
Models: HH-150T-DFV / HH-220T-DFV
Axle
Spacer
Safety Guard
Figure 3
Dual Fusion Forced Air Heater User's Manual
5
Handle
Wheel Support Frame
Publicité
