Servo Installation; Troubleshooting - XciteRC Sand Storm one10 2WD brushed blue Mode D'emploi

Troubleshooting

Servo installation

Troubleshooting
Problem
Motor does not run Motor cable unplugged or broken
Drive battery empty
Throttle trim TH.TRIM on the transmitter set
incorrectly
Motor broken
Vehicle runs back- Throttle servo reverse switch TH.REV in R
wards position
Weak motor / no Battery is almost empty
power Throttle trim TH.TRIM on the transmitter set
incorrectly
Drive train does not run smoothly
Vehicle is very loud
Motor gets very hot
Vehicle is hard to Transmitter LEDs fl ashing - transmitter bat-
control teries almost empty
Steering trim ST.TRIM on the transmitter set
incorrectly
Interference
Throttle trim TH.TRIM on the transmitter set
incorrectly
Vehicle has no LEDs on the transmitter does not light up
function
Transmitter - receiver not bound
Interference
Throttle trim TH.TRIM on the transmitter set
incorrectly
Car aerial torn off
Transmitter LEDs fl ashing - transmitter bat-
teries almost empty
Drive battery empty
Vehicle runs very Gear mash between the pinion and main
loud gear set incorrectly
Worn gears
Bearings runs tight or worn out
Sand Storm one10
Possible Cause Solution
Insert the motor cable or solder
Change or charge the battery
Check transmitter, set trim correctly
Replace the motor
Set servo reverse switch in position N
Change or charge the battery
Check transmitter, set trim correctly
Check drive train and clean if necessary
Check pinion clearance, adjust if necessary
Allow motor to cool; check drive train for
binding parts and precise gear mesh
Change or charge the battery
Check transmitter, set trim correctly
Turn off the vehicle and transmitter, make a
quick break and then re-try
Set throttle trim to the center position
Check that vehicle and transmitter are tur-
ned on
Rebind transmitter - receiver (see chapter
BINDING)
Set throttle trim to the center position
Repair antenna (vehicle)
Change or charge the battery
Change or charge the battery
Check gear mesh adjust if necessary
Check and replace if necessary
Check and lubricate or replace if necessary
EN
25