emerio MG-129337.1 Mode D'emploi page 8

Making cookie
1. Insert the auger into the head by turning the auger slightly until it is properly set.
Attach the cookie holder onto the auger shaft, and then the cookie cup.
Put on the fixing ring; screw firmly. Do not over tighten.
2. Assemble the head onto the machine. Press the release button with one hand; hold and insert the head
into the machine with the other hand, turning it anti-clockwise until it cannot move any further; release
the button. The head now is fixed onto the machine.
Caution: Make sure the appliance is unplugged when assembling.
3. Attach the funnel onto the head and fix it into position. Insert the cookie plate through the cookie cup.
Note: There are four molds on the cookie plate. Choose your desired one and set it in front of the cookie
cup.
4. Place a clean container under the machine to hold the cookie come from the appliance.
5. Ensure the ON/OFF/Reverse switch is set at position "0" (OFF), and then plug in the appliance.
6. Press the ON/OFF/Reverse switch to position "ON".
7. Form your prepared dough into a roll and then feed it into the funnel. Cut the cookie bar into the desired
size. Bake and serve.
Important: The max. operation time per cycle shall not exceed 7 minutes and minimum of 10 minutes rest
time must be maintained between two consecutive cycles.
8. After use, press the ON/OFF/Reverse switch to position "0" (OFF) and then unplug the appliance.
Detach the head from the machine. Press the release button with one hand; turn the head clockwise and
remove it from the appliance with the other hand; release the button.
Reverse function
1. In case of jamming, press the ON/OFF/Reverse switch to position "0" (OFF). Wait at least one minute until
the auger comes to a complete stop.
2. Press the ON/OFF/Reverse switch to position "R" (Reverse), the auger will be rotating anti-clockwise and
the head will get empty. If it does not work, press the ON/OFF/Reverse switch to position "0" (OFF),
unplug the appliance and clean the head.
Note: The max. operation time of the "R" position shall not exceed 5 seconds.
CLEANING AND MAINTENANCE
1. Unplug the appliance before cleaning.
2. Disassemble all parts and then wash them in water.
Caution: The blades are sharp. Handle with care.
3. Wipe the outside surface of the main body with a damp cloth and then dry thoroughly.
Note: Never immerse the main body in the water for cleaning. Only the sausage attachment, kibbe cone,
kibbe shaper, cookie cup, cookie holder, cookie plate, grinding blade, funnel and pressing rod are
dishwasher safe.
- 7 -