Publicité
Les langues disponibles
Les langues disponibles
If there is no water in the appliance, the red LEDs (8 and 12) light up in all
modes (normal and night mode). The red light can not be dimmed.
5. You can use the Oskar little air humidifier to distribute fragrances in the
room. Please be as economical as possible in the use of fragrances, be-
cause excessive quantities may lead to malfunctions and damage to the
appliance. To use fragrances, remove the fragrance container (10) from
the filling opening (9). Place no more than 2–3 drops of fragrance in the
container and replace it in the space provided in the filling opening. If you
wish to change the fragrance, you can wash out the fragrance container
and fleece under running water.
6. If you wish to top up with water during operation, you can open the filling
opening (9) by pressing on it (Push to open). You can then refill the appli-
ance using a water can or water bottle without having to switch it off.
PLEASE NOTE: If you are operating the appliance with fragrances, remove
the fragrance container before refilling to prevent water getting into it.
Should this nevertheless occur, it will be necessary to remove the water
container (2) and rinse it. Fragrances should not be permitted to enter the
water tank, since they might destroy the plastic.
Important information
With an evaporator, humidification can take a bit longer than it does when
using a nebuliser or vaporiser. So Oskar little takes a while to achieve a
measurable humidification result. If you operate the humidifier in a very dry
environment we recommend to operate it on speed level 2 to reach a maxi-
mum amount of humidity in a short time.
Cleaning
Prior to any maintenance, cleaning and after each use, switch off the appli-
ance and unplug the mains cable (3) from the socket.
Attention: Never submerge the appliance in water (danger of short-circuit).
For hygienic reasons and to ensure proper operation, we recommend the
following cleaning intervals.
• Daily: Fill the appliance with fresh, cold tap water. If the appliance is not
used for several days, empty the water from the lower part (2) beforehand
and if necessary, clean it with a bit of dish detergent and a clean cloth.
Fill fresh water into the lower part (2) before putting the appliance back
into operation.
• Every 2 weeks: First remove the filter (11) and the Water Cube™ (13).
Clean the inside of the lower part (2) thoroughly every 2 weeks with a bit
of dish detergent, warm water and a soft, clean cloth, sponge or brush.
Then rinse the lower part (2) thoroughly with cold water and put the filter
and the Water Cube back in.
• Approx. every 4 weeks (depending on the hardness of the water): First
remove the filter (11) and the Water Cube™ (13). In the case of limescale
deposits on the inside of the lower part (2), we recommend using the
Stadler Form Cleaner & Descaler (www.stadlerform.com/accessories).
Alternatively, you can use a household decalcifier or vinegar. Then rinse
the lower part (2) thoroughly with cold water and put the filter and the
Water Cube back in. For hygienic reasons, the filter (11) must be replaced
every 2–3 months.
Publicité
