Stadler Form Oskar little Mode D'emploi page 7

• Do not pull the plug from the socket with wet hands or by holding on to
the power cord.
• Do not use the appliance in immediate vicinity of a bath tub, a shower or a
swimming pool (observe a minimum distance of 3 m). Place the appliance
such that a person in the bath tub cannot touch the appliance.
• Do not place the appliance near a heat source. Do not subject the power
cord to direct heat (such as a heated hotplate, open flames, hot iron sole
plates or heaters for example). Protect power cords from oil.
• See to it that the appliance is properly positioned to ensure a high stabil-
ity during its operation and make sure that no one can trip over the power
cord.
• The appliance is not splash-proof.
• For indoor use only.
• Do not store the appliance outdoors.
• Store the appliance in a dry place inaccessible to children (pack the ap-
pliance).
• If the power cord is damaged, it must be replaced by the manufacturer
or a repair shop authorized by the manufacturer or by similarly qualified
persons in order to avoid a hazard.
• Be aware that high humidity levels may encourage the growth of biologi-
cal organisms in the environment.
• Unplug the appliance during filling and cleaning.
• Never leave water in the water container when the appliance is not in use.
• Clean the water container every 3 days
• Empty and clean the humidifier before storage. Clean the humidifier be-
fore next use.
• Warning: Micro-organisms that may be present in the water or in the en-
vironment where the appliance is used or stored, can grow in the water
container and be blown in the air causing very serious health risks.
Setting up / operation
1. Place Oskar little on a flat surface in the desired area. Use the filling open-
ing (9) to fill the lower part (2) with water up to the maximum mark (12),
either at a water tap or with a watering can. When you have filled the
lower part at the tap, carefully fit the upper part (1) to the lower part (2).
Plug the mains cable (3) into a electric socket.
2. Start the appliance by pressing the on/off switch (5). The blue LED should
then light up. If a red pilot lamp (8 and 12) lights up however, this indicates
either lack of water in the appliance or failure to seat the upper part cor-
rectly on the lower part.
3. By pressing the speed level selector button (6) you can change the humid-
ity output (a blue lamp for normal evaporation, two blue lamps for high
evaporation).
4. If you find the lamps too bright (in a bedroom for example), you may reduce
the light intensity by pressing the night mode key (7). You can choose
between three different modes:
• Normal mode (default mode)
• Dimmed mode (push once)
• Lights-out mode (push twice)
• By pushing the dimmer button once more, you can go back into normal
mode.