Danby DPA100B9IWDB-6 Manuel Du Propriétaire page 16

OPERATING INSTRUCTIONS
CONTROL PANEL
1. Swing and wireless connect button:
• Press to start the auto swing feature.
• Press and hold for three seconds to start
using the wireless connect feature.
2. Timer button: Press to set the automatic timer.
Light will indicate whether a timer is set.
3. Mode button: Press to select the desired mode.
Light will indicate current mode.
4. Temperature control buttons:
• Press to modify the set temperature in 1°
increments in a range of 16 - 30°C (60 -
86°F).
• Press to modify the timer setting in 0.5 hour
increments up to 10 hours and then in 1
hour increments up to 24 hours.
• Press and hold both temperature control
buttons for three seconds to change the
temperature display from °C to °F.
5. LED display:
• Shows the set temperature in °C or °F.
• Shows the timer settings.
• Shows error codes.
• When on fan mode, shows the room
temperature.
6. Fan button:
• Press to select fan speed. Light will indicate
current speed.
• Press and hold for 3 seconds to turn the
continuous fan on or off.
7. Sleep and fi lter button:
• Press to start the sleep feature.
• The fi lter light will illuminate after 250 hours
of use as a reminder to clean the fi lter; to
reset the fi lter after cleaning, press and hold
the sleep button for three seconds.
8. Power button: Press to turn the appliance on or
off.
4
1 2 3
3sec
5
6
7
3sec
OPERATING MODES
Cool Mode
• Choose cool mode to set the cooling function.
• Use the temperature control buttons to choose the
desired temperature.
• Use the fan button to choose the desired fan speed.
• The temperature can be set within a range of 16 -
30°C (60 - 86°F).
• The exhaust hose should be installed.
Dry Mode
• Choose dry mode to remove excess moisture from
the air. Water will condense inside the appliance
and drain out the back.
• The humidity level and fan speed will be
automatically set and cannot be modifi ed in dry
mode.
• The display will show the current room
temperature.
• The exhaust hose does not need to be connected to
the window kit.
• It may be necessary to install the continuous drain
hose during dry mode to remove excess water.
Fan Mode
• Fan mode can be used to run the fan without
engaging the cooling or dehumidifying functions.
• Use the fan button to choose the desired fan speed.
• The exhaust hose does not need to be connected to
the window kit.
• In cooling or dry mode, press and hold the
fan button for 3 seconds to set the fan to run
continuously. Press and hold the fan button for 3
seconds to disengage the continuous fan. During
normal operation the fan will turn on and off with
the compressor.
Auto Mode
Auto mode is a pre-set factory program that
automatically chooses between cool or fan mode and
sets the fan speed based on the set temperature and
the ambient temperature. The exhaust hose should be
installed during auto mode.
8
15