Danby DPA100B9IWDB-6 Manuel Du Propriétaire page 12

INSTALLATION INSTRUCTIONS
WINDOW KIT ASSEMBLY
Step one: prepare the window sliders
1. Measure the window opening where the window
kit will be installed.
2. Assemble as many sliders as necessary to fi t the
window. If the window opening is less than the
minimum length of a single slider, use the slider
that has the hole in it and cut it to the correct
length. Make sure not to cut the end that has the
hole as this is necessary to attach the exhaust
hose adapter.
3. Use the window slider bolts to secure the
window sliders at the correct length.
A
A
Bolt
B
Bolts
B
C
Step two: prepare the exhaust adapter (for
optional sliding window applications)
Assemble the exhaust adapter module for sliding
windows using the exhaust adapter screw as shown.
The window slider is eccentric so the exhaust
adapter must be installed away from the wall.
A
B
EXHAUST HOSE
Pull out the hose
1. Rotate the exhaust hose gently backwards.
2. Pull out the exhaust hose.
11
screw
C