Husqvarna PG 510 Manuel D'utilisation page 2

Introduction..................................................................... 2
Safety..............................................................................4
Operation........................................................................ 7
Maintenance................................................................. 13
Owner responsibility
WARNING Cutting, especially when DRY
cutting, generates dust that comes from the
material being cut, which frequently contains
silica. Silica is a basic component of sand,
quartz, brick clay, granite and numerous
other minerals and rocks. Exposure to
excessive amount of such dust can cause:
Respiratory disease (affecting your ability to
breathe), including chronic bronchitis,
silicosis and pulmonary fibrosis from
exposure to silica. These diseases may be
fatal;
Skin irritation and rash.
Cancer according to NTP* and IARC* */
National Toxicology Program, International
Agency for Research on Cancer.
Take precautionary steps:
Avoid inhalation of and skin contact with
dust, mist and fumes.
Wear and ensure that all bystanders wear
appropriate respiratory protection such as
dust masks designed to filter out
microscopic particles. (See OSHA 29 CFR
Part 1926.1153)
To minimize dust emissions, wet cut when
feasible. If dry cutting is necessary, use an
appropriate dust extractor.
It is the owner's/employer's responsibility that the
operator has sufficient knowledge about how to use the
product safely. Supervisors and operators must have
read and understood the Operator's Manual. They must
be aware of:
2
Contents
Troubleshooting............................................................ 14
Transportation and storage...........................................15
Technical data.............................................................. 17
Introduction
• The products's safety instructions.
• The products's range of applications and limitations.
• How the product is to be used and maintained.
National/Local regulations could restrict the use of this
product. Find out what regulations are applicable where
you work before you start using the product.
Product description
The product is a power grinder for concrete surfaces of
different hardness. The grind range is from rough
surfaces through to smoother finish.
For example, the product has these functions:
• A frame that can be folded for easier transport.
• A grinding head cover that adjusts the movement to
the surface layer.
• The grinding head has 3 grinding discs. Full set is
with 6 segments on each grinding disc.
• Resin holder, a holder for plastic bonded diamond
tools.
• Available in 1- or 3-phase.
• A grind width of 515 mm.
Intended use
Use the product to grind concrete surfaces with different
hardness such as terazzo and stone tiles.
The product is used for light commercial operations at
private properties and small commercial spaces.
WARNING Do not use the product for other
tasks.
1146 - 001 - 29.04.2019