Publicité
Les langues disponibles
Les langues disponibles
Attaching Rip Fence (figure F & G)
- Insert rip fence into slots of shoe with the
cross bar (13) facing down as shown in
figure F.
- Place screw (14) into hole in bottom of
shoe.
- Align clamp bar (15) over screw with
lipped edge facing down and pointing
towards the rear of the saw.
- Using a phillips screwdriver, run the
screw into the threaded hole in the bar
clamp as shown in figure G.
- Adjust to width of cut and tighten screw.
F
14
G
Circle Cutting (FIGURE H)
- Insert rip fence into slot on the right side
of saw shoe with cross bar facing up.
- Adjust rip fence so that distance from
blade to hole in cross bar is the desired
radius and tighten screw.
- Place saw so that center of hole in cross
bar is over center of circle to be cut (make
pocket cut, drill hole for blade or cut inward
from edge of material to get blade into
position).
- When saw is properly positioned, drive
a small nail through hole in cross bar into
exact center of circle to be cut. Using rip
fence as a pivot arm, begin cutting circle.
H
15
13
Pocket Cutting (FIGURE I)
A pocket cut is an easy method of making
an inside cut. The saw can be inserted
directly into a panel or board without
first drilling a lead or pilot hole. In pocket
cutting, measure the surface to be cut and
mark clearly with a pencil. Next tip the saw
forward until the front end of the shoe sits
firmly on the work surface and the blade
clears the work through its full stroke.
Switch the tool on and allow it to attain
maximum speed. Grip the saw firmly and
lower the back edge of tool slowly until the
blade reaches its complete depth. Hold
the shoe flat against the wood and begin
cutting. Do not remove blade from cut while
it is still moving. Blade must come to a
complete stop.
I
MAINTENANCE
Use only mild soap and damp cloth to clean
the tool. Never let any liquid get inside the
tool; never immerse any part of the tool into
a liquid.
IMPORTANT: To assure product SAFETY
and RELIABILITY, repairs, maintenance
and adjustment should be performed by
authorized service centers or other qualified
service organizations, always using identical
replacement parts.
ACCESSORIES
WARNING:
not recommended for use with this tool
could be hazardous.
Recommended accessories for use with
your tool are available from your local dealer
or authorized service center. If you need
assistance regarding accessories, please
call: 1-800-544-6986.
SERvICE INFORMATION
All BLACk+DeCkeR Service Centers are
staffed with trained personnel to provide
customers with efficient and reliable power
tool service. Whether you need technical
6
The use of any accessory
Publicité
