Publicité
Les langues disponibles
Les langues disponibles
Steam cleaning
Assembly of appliance
3
Steam cleaning
illustrated Quick Start Guide (Page 2).
Filling water tank
1. Make sure that the appliance is switched off and the plug is pulled out.
Steam cleaning
1. Make sure that surface is suitable for hot steam cleaning.
If in doubt, contact manufacturer of surface to be cleaned. TIP: It could also be useful to sweep
or vacuum surface first.
2. Place cable into clip on handle to avoid running over it when cleaning.
3. Put clean cleaning cloth underneath (cleaning strip on top) and place mop head on it. To freshen
carpets, also put the carpet glider underneath.
16
2. Fill supplied filling flask with cold tap water.
Never put additives in water tank!
3. Open cap on water tank and empty filling flask into wa-
ter tank as shown.
4. In doing so, do not overfill water tank. Always observe
fill level.
5. Close cap on water tank.
illustrated Quick Start Guide (Page 2).
4. Insert plug into outlet. The LED is lit.
5. Wait approx. 30 seconds.
6. Use handle to pump approx. 10 times, until cleaning
cloth is saturated with sufficient steam.
7. Then adapt the amount of steam discharged by pump-
ing movements.
8. Clean floor with hot steam just as you would with a mop.
While doing so, do not remain in one spot for any period
of time illustrated Quick Start Guide (Page 3).
Publicité
