Thermador T36BT110NS Guide D'utilisation Et D'entretien page 23

Press and hold Lock Water until the light bar lights up
2.
fully.
The water capacity favorites light up.
a
Water capacity
Your appliance has 4 water capacities at the factory and
these are stored as favorites on the display.
The predefined water capacities can be adjusted or
deleted.
Removing a favorite
Swipe to Water.
1.
Touch the desired favorite.
2.
Hold a glass below the water dispenser and press and
3.
hold until the water capacity has been fully removed.
Saving new favorites
Note: Max. 6 water capacities can be stored.
Swipe to Water.
1.
Hold a glass below the water dispenser, and press and
2.
hold until the desired water capacity has been
removed.
Touch Save as Favourite.
3.
Touch the desired name.
4.
Touch the desired color.
5.
Touch ⁠ .
6.
The new favorite is saved.
a
Adjusting a favorite
Swipe to Water.
1.
Touch the desired favorite.
2.
Touch ⁠ .
3.
Touch the desired name and confirm using ⁠ .
4.
Touch the desired color and confirm using ⁠ .
5.
The favorite is adjusted.
a
Deleting a favorite
Swipe to Water.
1.
Touch the desired favorite.
2.
Touch ⁠ .
3.
Touch Delete favourite and use Yes, delete to confirm.
4.
The favorite is deleted.
a
18.3 Ice maker
Use the different functions of the ice cube maker to
produce ice cubes.
WARNING
Rotating parts may cause injury.
Never reach into or underneath the ice maker.
▶
⁠ Ice
Quick Ice
Ice cube production
Accelerated ice cube
production
Note: ⁠ "Quick Ice" is only
available if ice cube
production is switched on.
Note: The ice cube maker automatically detects that the
ice storage container is full and stops producing ice cubes.
The display shows ⁠ .
It may take up to 48 hours until the ice storage container is
full.
Tip: If the ice cubes taste stale, dispose of the remaining
ice cubes and the cubes produced over the next 24 hours.
If the ice cubes still taste stale, change the water filter.
Putting the ice maker into operation
Notes
Ice cube production starts as soon as the appliance is
¡
switched on and the freezer compartment has reached
the set temperature.
As soon as the freezer compartment reaches the set
¡
temperature, the first batch of ice cubes will be ready in
approximately 4 hours.
Requirement: The appliance is connected to the drinking
water connection.
For hygiene reasons, discard the ice cubes produced
▶
within the first 24 hours.
Switching on ice cube production
Touch the ice cube maker setting and confirm using
1.
⁠ .
Switch on the desired ice cube production.
2.
Switching off ice cube production
Touch the ice cube maker setting and confirm using
1.
⁠ .
Switch off the desired ice cube production.
2.
Water system en-us
23