Cleaning The Hepa Filter - Robusta CYCLONIC 11 Manuel D'utilisation

EN
11. To put the dust container and the fi lter unit back together
again, you must insert the fi lter unit in such a way that the upper
arrow points towards the open lock symbol.
12. Turn the dust container lid until the upper arrow points towards
the closed lock symbol and locks in place.
13. Insert the dust container back into the vacuum cleaner.
The dust container must be heard to engage in place.

Cleaning the HEPA Filter

The HEPA fi lter is located in the fi lter unit in the dust container and should be cleaned regularly
to ensure that the suction power of your vacuum cleaner does not diminish and the motor
is not overloaded.
1. Hold down the release button on the handle of the dust container
and detach the dust container from the vacuum cleaner.
2. Open the dust container by releasing the fastener clip (A) and
folding up the dust container lid.
3. Remove the HEPA fi lter (B) by pulling it out.
4. Below the HEPA fi lter there is another foam fi lter. Remove it
for cleaning.
5. Tap the HEPA dust fi lter out over an open dustbin. Clean the fi lter using a brush if necessary. Never
clean the HEPA fi lter with water to prevent damage to the fi lter!
6. Tap the foam fi lter out over an open dustbin. If necessary, you can rinse the foam fi lter with clear, cold
water. Then allow the fi lter to dry completely before you insert it again.
7. Place the dry foam fi lter back into the fi lter unit.
8. Insert the HEPA fi lter back into the fi lter unit.
9. Close the dust container lid. The fastener clip must be heard to lock in place.
23