Pulling Out The Telescopic Tube - Robusta CYCLONIC 11 Manuel D'utilisation

EN
The combi fl oor nozzle is suitable for both carpets and hard
fl oors.
The foot switch allows you to change between carpet and
hard fl oor. A brush and a rubber lip are extended on the underside
of the nozzle for use on hard fl oors.
The upholstery nozzle is suitable for cleaning all kinds of upholstery,
e. g. sofas, car seats etc.
• The crevice nozzle is suitable for upholstery, cleaning the
inside of cars and for all nooks and crannies that cannot be
reached with the other nozzles.
• The brush nozzle is suitable for all uneven objects, furniture,
lamps, profi les and skirting boards, window ledges, etc.
There is an arrow mark on the crevice nozzle.
To turn the crevice nozzle into a brush nozzle,
all you have to do is fold the end of the crevice
nozzle in the direction marked by the arrow.

Pulling Out the Telescopic Tube

1. Press the slider on the telescopic tube in the direction shown
by the arrow and pull the telescopic tube out to the length
you want.
2. Let go of the slider and carry on pulling out the telescopic
tube until it locks in place.
Use
* Never hold the nozzles close to parts of your body during use and do not place your hands inside the
nozzles. They could become stuck to the device/injured. If the vacuum cleaner becomes fi rmly attached due
to suction, turn it off immediately (press down the On / Off switch).
* Keep the nozzles away from animals during operation. Never attempt to vacuum animals using the device.
They could become stuck to the device/injured. If the vacuum cleaner becomes fi rmly attached due to
suction, turn it off immediately (press down the On / Off switch).
* Switch on the vacuum cleaner only when you have checked that all parts have been properly assembled
and that the dust container and all fi lters have been inserted correctly.
* To ensure that the cable does not become hot during operation, pull out at least two thirds of its total
length from the device before you switch on the vacuum cleaner. Do not pull out the cable with force up to
its maximum length (not further than the red marking on the cable) in order to prevent damage!
* Always switch the device off fi rst and remove the mains plug from the mains socket before replacing a
nozzle or attaching or removing any accessories.
* On no account should the device be used to suck up the following:
– Liquids or wet substances (e.g. wet carpet shampoo)
– Glowing ash, cigarette ends, matches, etc.
– Infl ammable or explosive substances
– Very fi ne dust (e.g. concrete dust), ash or toner
– Pointed, hard objects such as large pieces of broken glass.
20