Speed Damping; Calibrating The Water Temperature; Calibrating By Speed - ADVANSEA SPEED S400 Manuel Utilisateur

2.4.1. Speed damping

A damping coefficient is available to the user for boat speed. Depending on navigation
conditions, this parameter can be adjusted to between 1 and 30.
menu
Press for 2 seconds, then on
adjust the required value using the
Press to exit setup mode, or time out after 10 seconds.

2.4.2. Calibrating the water temperature

The water temperature is calibrated in the calibration menu, by replacing the water
temperature displayed with the water temperature estimated by the user, or measured
using another source.
menu
Press for 2 seconds, then on
adjust the required value using the
Press to exit setup mode, or time out after 10 seconds.

2.4.3. Calibrating by speed

The speedometer sensor can be calibrated by speed or by distance.
menu
until the "dAM" setup page is displayed, then
and
2 seconds
menu
until the "CAL" setup page is displayed, then
and
2 seconds
Installation and Operation Manual S400 series
keys.
keys.
12