poolstar SPAWER POOLEX O'SPA Manuel D'installation Et D'utilisation page 47

4.3 Functions overview
The indicators to the right of the control panel indicate the O'SPA heat pump's other functions.
4.4 Heat pump operating mode selector
By default, the heat pump is in heating mode.
To change the mode of use, when the heat pump is ON:
• Press the button
• Press the button again
• Press the button again
The different modes thus form a cycle:
Good to know:
The heat pump can take several minutes to change operating mode in order to preserve the
refrigerant fluid.
The maximum set temperature is 40°C.
4. Use
WiFi indicator
Indicates your Wifi connection status.
Flashes during pairing (see paragraph 4.9 "Pairing the heat
pump"). It remains on when a connection is active.
Circulation pump indicator
On when the circulation pump is active:
• Fixed light in automatic mode,
• Flashing in manual mode.
Heater pilot indicator
The RECH light is on when the heater is active:
• Fixed light in automatic mode,
• Flashing in manual mode.
for 3s, the heat pump will then switch to cooling.
for 3s, the heat pump will then switch to automatic.
for 3s, the heat pump will then switch heating.
EN | 16