Publicité
Les langues disponibles
Les langues disponibles
•
Remove clippings, dirt etc from the underside of the deck and cutting blades (the deck wash function on some
models assists this procedure).
•
It is recommended to lightly oil the cutting blades after each use to help prevent corrosion.
•
Ensure all chutes and flaps are clean and not obstructed.
•
Ensure that spring-loaded parts, such as the rear guard, return to the normal position when released.
•
Clean and check the grass catcher for any damage, replace damaged parts. Allow the grass catcher to dry
thoroughly before storing to prevent mildew or deterioration of the catcher netting (where applicable).
•
Ensure that all control cables, levers, switches etc are clean and operate normally and smoothly.
TROUBLESHOOTING
The table includes some of the most common problems, their causes and remedies.
PROBLEM
The machine does not work
The electrical protection is
activated
The machine leaves an uneven
finish
The cutting blade is blunt
There is excessive vibration/noise
TRANSPORTATION AND STORAGE
•
Allow the equipment to cool completely before transporting or storing it.
•
Always store the product in a clean, safe, dry place with temperatures between 0º and 45ºC.
•
The equipment is not weatherproof and should not be stored in direct sunlight, high temperatures or in damp
locations.
•
Always store the machine with the cutting element protection installed.
•
Store the machine out of the reach of children.
Check the power, and turn the machine on.
Check the plug, replace the blown fuse.
Allow the machine to cool down and increase the cutting height before
continuing.
The height of the cut is low, increase the height of the cut.
Replace the new blade.
The blade bolt is loose, tighten the blade bolt.
The cutting blade is damaged, replace the new blade.
SOLUTION
55
EN
Publicité
