Publicité
Les langues disponibles
Les langues disponibles
TROUBLESHOOTING TIPS
Before Calling For Service
Reviewing the charts on the following pages may save you from calling for service.
Problem
Dishwasher doesn't
start
Water not pumped
from dishwasher
Foam
in the tub
Stained tub interior Detergent with
White film on
inside surface
Possible causes
Fuse blown, or the
circuit breaker tripped.
Power supply is not
turned on.
Door of dishwasher
not properly closed.
Kink in drain hose
Filter clogged.
Kitchen sink clogged.
Improper detergent
Spilled
rinse aid
.
colourant may
have been used.
Hard water minerals.
19
Solution
Replace fuse or reset circuit breaker.
Remove any other appliances sharing the
same circuit with the dishwasher.
Make sure the dishwasher is turned on and
the door is closed securely.
Make sure the power cord is properly
plugged into the wall socket.
Make sure to close the door property and
latch it.
Check drain hose.
Check the coarse filter.
(see section titled " Internal Care ")
Check the kitchen sink to make sure
it is draining well. If the problem is
the kitchen sink that is not draining ,
you may need a plumber rather than
a serviceman for dishwashers.
Use only the special dishwasher detergent
to avoid suds. If this occurred, open the
dishwasher and let suds evaporate.
Add 1 gallon of cold water to the tub.
Close and latch the dishwasher, then
Start any wash cycle to drain out the
water. Repeat if necessary.
Always wipe up
rinse aid
immediately.
Make sure that the detergent has no
colourant.
To clean the interior,
soft cloth
with dishwasher detergent
and wear rubber gloves. Never use any
other cleaner than dishwasher detergent
for the risk of foaming or suds.
spills
use
the damp
Publicité
