Urmet YOKIS 1083/85 Manuel D'installation Et D'utilisation page 7

ENGLISH
The home automation interface 1083/85 allows for connection of the 1717/12H Modo monitor of the 2Voice
system to the YOKIS Home Automation Radio Bus.
With this device, from the 1717/12H monitor it will be possible to activate up to 8 scenarios in a simple and
intuitive manner.
As the monitor is connected to the home automation interface 1083/85, the call repeat function
will no longer be available while the call to fl oor function can still be used.
DESCRIPTION OF COMPONENTS
1. Button used to enter the programming mode (if pressed briefl y) or reset the device (if held down for more
than 5 seconds).
2. Connection terminal strips.
3. Yokis control sent confi rmation blue LED.
4. Programming mode entered confi rmation yellow LED
INSTALLATION
Fix the device to the wall with screws and screw anchors (supplied), as shown below:
1
4
During fi nal installation, the fi xing systems must be able to adequately support the weight of
the product. It is therefore necessary to test the fi xing systems, applying an additional weight of
50 N on the product's centre of gravity for 1 minute and to then check their sturdiness.
DS1083-069A
All manuals and user guides at all-guides.com
4
3
2
1
2
5
3
6
7