Publicité
Les langues disponibles
Les langues disponibles
2
187
Using the Probe
1.
Connect the probe to the BNC
input of the oscilloscope.
2.
Select the desired volts/division
range on your oscilloscope.
3.
If possible, always turn the high
voltage source off before
connecting or disconnecting the
probe.
4.
Connect the divider probe
ground lead (alligator clip) to a
good earth ground or reliable
chassis ground.
5.
Before turning on the high
voltage source, be certain the
operator is not touching any
part of the device under test.
6.
Turn on the high voltage
source.
7.
You will now be able to analyze
the voltage waveform on your
oscilloscope.
8.
Turn off the high voltage
source.
9.
Disconnect the High Voltage
Probe from the high voltage
source BEFORE disconnecting
the ground clip lead.
www.
.com
7
information
Publicité
