Ryobi ACRM032 Mode D'emploi

FOR USE WITH RYRM8001
RYOBI ELECTRIC 30 IN. ZERO TURN LAWN MOWER
WARNING:
To reduce the risk of injury, user must read and under-
stand the operator's manual for their riding lawn mower
before using this accessory. Save these instructions.
Refer to them frequently and use them to instruct other
users. If you loan someone this product, loan them these
instructions also.
INSTALLING BLADES
See Figures 1 - 2.
WARNING:
Only use replacement blades and blade bolts authorized
by the manufacturer of your riding mower. Unauthorized
blades and/or blade bolts could break, allowing the blade
to come loose, resulting in possible serious personal
injury and damage to the mower.
NOTE: Make certain all parts are replaced in the exact order
in which they were removed.
 Move the mower to a level surface. Make sure joystick
is in the locked, neutral position and blade engage knob
is down.
 Stop the motor, remove the start key, and set the parking
brake.
 Raise the height of the cutting deck to its highest position
to allow access to blades.
NOTE: If necessary, raise the mower by placing on a lift
or using a jack and jack stands to gain access to the
blades.
WARNING:
If raising the mower to access the blades, make sure the
mower is properly secured and the parking brake is set
before proceeding. Failure to properly secure the mower
could cause it to fall, resulting in death or possible seri-
ous personal injury.
 Wedge a block of wood between the blade and mower
deck to prevent the blade from turning.
 Loosen the blade nut by turning it counterclockwise (as
viewed from bottom of mower) using a 15 mm wrench or
socket (not provided).
ACRM032 CROSSCUT
REPLACEMENT BLADES
WRENCH
BLOCK OF WOOD
BLADE
HALF
CIRCLE
HOLE
SPRING
WASHER
BLADE
NUT
English
BLADE
SHAFT
CIRCLE POST
BLADE
HALF CIRCLE
POST
CENTER
BLADE
HOLE
BLADE
CIRCLE HOLE
Fig. 1
BLADE
UPPER
BLADE
LOWER
BLADE
Fig. 2