Ryobi AC04017 Mode D'emploi

WARNING!
To reduce the risk of injury, user must
read and understand the operator's
manual for their lawn mower and this
instruction sheet. Always wear eye
protection with side shields marked
to comply with ANSI Z87.1. Ensure
compatibility and fit before using this
accessory. Do not use this accessory
if a part is damaged or missing. If you
are not comfortable performing any
of the functions described in these
instructions, take your unit to a quali-
fied service center.
WARNING:
Always protect hands by wearing
heavy gloves and/or wrapping the
cutting edges of the blade with rags
and other material when performing
blade maintenance. Contact with the
blade could result in serious personal
injury.
REPLACING THE CUTTING
BLADE
See Figures 1 - 2.
 Stop the motor. Allow blade to come
to a complete stop.
 Disconnect the power supply.
 Turn the mower on its side.
TECHTRONIC INDUSTRIES POWER EQUIPMENT
LAWN MOWER BLADE
AC04017
For use with RYOBI 20 in.
®
Electric Lawn Mower ONLY
 Wedge a block of wood between the
blade and mower deck to prevent the
blade from turning.
 Loosen the blade bolt by turning it
counterclockwise (as viewed from
bottom of mower) using a 15 mm
wrench or socket (not provided).
 Remove the blade bolt and blade.
 Install the new blade. Ensure blade
is properly seated with the two blade
posts inserted into the holes on the
blade. Make sure it is installed with
the curved ends pointing up toward
the mower deck and not down toward
the ground. When seated properly,
the blade should be flat.
 Reinstall the blade bolt and finger
tighten.
NOTE: Make certain all parts are
replaced in the exact order in which
they were removed.
 Torque the blade bolt down clockwise
using a torque wrench (not provided)
to ensure the bolt is properly tight-
ened. The recommended torque for
the blade bolt is 350 – 400 in. lbs.
WARNING:
Ensure blade is properly seated and
the blade bolt is tightened to the
torque specifications above. Failure
to properly attach the blade could
cause it to come loose or detach and
result in possible serious personal
injury.
P.O. Box 1288, Anderson, SC 29622 USA
1-800-525-2579 • www.ryobitools.com
Fig. 1
A
B
C
A - Blade (lame, hoja)
B - Wrench (clé, llave)
C - Block of wood (pièce de bois, bloque de
madera)
Fig. 2
C
A
E
B
D
A - Blade (lame, hoja)
B - Blade bolt (boulon de lame, perno de la hoja)
C - Blade post (half circle) [tige pour lame (demi-
cercle), puerto de la hoja (semicircular)]
D - Bolt hole (round) [trou pour boulon (ronde),
orificio de la perno (redondo)]
E - Post hole (half circle) [trou pour tige (demi-
cercle), orificio del poste (semi-circular)]
F - Spacer (pièce d'écartement, separador)
1-26-21 (REV:01)
C
E
F
998000532