Sony VPL-VZ1000 Guide De Référence Rapide page 8

Image distortion
Side view
c < 90°
If the frame of the projection surface is rectangle and
parallel to the floor, adjustment is completed.
Tip
If the picture remains distorted, repeat step 2 and 3.
5
Adjust the feet for preventing backlash to the floor.
Note
The picture may be distorted if you turn the feet for preventing
backlash too much.
6
Press the PATTERN button to display the Lens Shift
adjustment window, and adjust the picture position by
pressing the M/m/</, buttons.
2.35:1
The dashed lines show the screen sizes of
each aspect ratio.
Tip
If you press the RESET button on the remote control while the
Lens Shift adjustment window is displayed, the picture
position returns to the center of the lens (factory default
position).
To adjust the horizontal position
When pressing the </, button, the picture
projected on the screen moves right or left by a
maximum of 3% of the screen width from the center
of the lens.
8
US
Adjusting
Feet adjustment
Adjust the foot
near the rear
side so that it is
longer.
Adjust the
height with the
feet near the
front side.
1.78:1 (16:9)
Top view
3%* 1 screen width
: Picture position when moving the picture to the left at
maximum
: Picture position when moving the picture to the right at
maximum
* For 17:9 display, the range of movement will be +/
To adjust the vertical position
When pressing the M/m button, the picture projected
on the screen moves up or down by a maximum of 6%
of the screen height from the center of the lens.
Side view
6%
1 screen
height
6%
: Picture position when moving the picture upward at
maximum
: Picture position when moving the picture downward at
maximum
7
Press the PATTERN button again to display the Lens
Zoom adjustment window. Then adjust the size of the
picture by pressing the M/m/</, buttons.
To make the picture larger, press M/,.
To make the picture smaller, press m/<.
3%*
_
2.8%.