LG W09UH Manuel De L'utilisateur page 10

4
FAN SPEED SELECTOR
For increased power while cooling or heating, select a higher fan speed.
Cooling Model: 3 steps{High[F3]
Heating Model: 2 steps{High[F2]
5
TEMPERATURE CONTROL
The thermostat monitors room temperature to maintain the desired temperature.
The thermostat can be set between 16°C~30°C (61°F~81°F).
The unit takes an average of 30 minutes to adjust the room temperature by 1°C (1.8°F).
6
AUTO SWING BUTTON (available in some models)
Allows the unit to automatically swing its louvers left and right during operation. If the option is
de-selected, the louvers will stop in their last position and orient the airflow in the corresponding direction.
7
REMOTE SENSOR
Auto Restart
In case the power comes on again after a power failure, Auto Restarting Operation is the function to operate
procedures automatically to the previous operating conditions.
Inserting the Remote Control Batteries
1
Push out the cover on the back of the remote control with your thumb
2
Pay attention to polarity and insert two new AAA 1.5V batteries.
3
Reattach the cover.
NOTE: Do not use rechargeable batteries. Make sure that both batteries are new.
• In order to prevent discharge, remove the batteries from the remote control if the
air conditioner is not going to be used for an extended period of time
Keep the remote control away from extremely hot or humid places.
To maintain optimal operation of the remote control, the remote sensor should
not be exposed to direct sunlight.
• The remote control can be mounted on a wall using the mountable holder.
Low[F1] Med[F2]
Low[F1]
10