Publicité
ATTENTION:
The chuck guard is electrically interlocked. For machine
operation, the chuck guard must be closed.
5.3 Mains connection
Mains connection and any extension cords and plugs used
must comply with the information on the machine licence plate.
The mains connection must have a 10A surge-proof fuse.
Only use connection cables marked H07RN-F, with wires
1,5mm2 or more.
Power cords and plugs must be free from defects.
Connections and repairs to the electrical equipment may only
be carried out by qualified electricians.
The machine is equipped with 1.8m power cord and plug.
ATTENTION:
-Check at first if the machine spindle rotates freely and if all
safety devices are fitted before starting the machine.
- If the direction of rotation is not correct, the phase converter
inside the CCE Euro plug must be pushed in and turned 180°
(400V version only).
Clockwise direction of the spindle is correct.
5.4 Dust collection
Wood dust is explosive and can represent a risk to health.
Assure good work area ventilation.
Use a suitable dust collection and air filtration system to avoid
a high dust concentration in the air.
Dust the machine down after each use and as necessary.
5.5 Starting operation
Start the machine with the green ON-button (C, Fig 16).
The red OFF-button (B) stops the machine.
Fig 15
The E-stop button (A) stops all machine functions.
The machine lamp can be turned ON/OFF independently (D).
The cross laser can be turned ON/OFF independently (E).
ATTENTION:
In case of machine overload the motor overload cut-off will
react. After appr.10 min of cooling the machine can be
started again.
Cuck guard and pulley cover are electrically interlocked. For
machine operation, both must be closed.
The LED indicator (F) will display a "white" light in the ready
state; whenever there is power connected to the drill press.
The LED indicator (D) will display a "green" light when the
start button has been pressed and the drill press is operating.
6. Machine operation
Before each operation of your drill press, check that all locking
handles, set screws, bolts, etc., are tight on the table and
head. Confirm that the drill bit is securely inserted inside the
chuck jaws.
Clear all items, such as tools and rags, away from machine.
Before attempting regular work, get the feel of the drill press
by practicing on scrap material. For best results, always use
sharp bits, and proper spindle speeds and feed rates.
For through-boring, remove the table insert.
To minimize tear-out, place a piece of scrap wood on the
table below the work piece.
Always adjust the table and the depth stop to prevent drilling
into the table. Use a back-up piece of scrap wood to cover the
table. This protects both the table and the drill bit.
Secure work piece to the table with clamps or a vice to
prevent rotating with the drill bit.
Feed the bit into the material with only enough force to allow
the drill bit to work. Feeding too slowly may cause burning of
the work piece. Feeding too quickly may cause the motor to
stop and/or the drill bit to break.
Fig 16
Publicité
