Télécharger Imprimer la page

Clatronic BS 1312 A Mode D'emploi page 47

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 21
When the charging process of the battery is completed,
you should disconnect the charger immediately. A charge
up to 90 % is considered best.
Conversely, it is also preserving the battery more when
it is not discharged to 0 %. If the possibility arises, you
should already recharge the battery when it is reaching a
charge state of 30 %.
• Storage: Always store batteries in a dry place and at
moderate temperatures between 10 °C and 20 °C.
Also consider the effect of self-discharge! When the
accumulator is already empty, this effect may lead to
a deep discharge resulting in damaging the battery. If
you intend to store the battery for an extended period of
time, you can counteract this effect. We then recommend
charging the battery to approx. 40 % before storage. You
should check the state of charge after not more than a
month.
Unpacking the Appliance
1. Remove the appliance from its packaging.
2. Check the delivery scope for completeness.
3. Check the appliance for any transport damage, in order
to prevent hazards.
NOTE:
In case of any transport damage, contact your dealer
immediately. Do not use a damaged appliance!
Overview of the Components /
Scope of Delivery
1 Indicator lights
2 ECO button
3 On / off button
4 Carrying handle
5 Power supply connection socket
6 Cover closure (Outlet filter)
7 Exhaust filter behind the cover
8 Motor housing / Hand set
9 Dust container
10 Base plate of the dust container
11 Opener / Locking of the base plate
12 Dust container latch MOVE
13 Floor nozzle with turbo brush
14 Floor nozzle release PUSH
15 Suction pipe
16 Suction pipe release PUSH
Wall Holder
17 Power supply connection socket
18 Slot for accessory holder
19 Slot for accessory holder
20 Charging contacts
21 Slot for accessory holder
BS1312A_IM
Accessories
22 Mini special brush
23 Large brush nozzle / Upholstery brush
24 Crevice nozzle
Not Shown
3 × Accessory holder
1 × Power adapter
2 × Wall plug
2 × Screw
Notes for Use
• The appliance is especially suitable for quickly vacuum-
ing small amounts of dry dirt or dust.
• The appliance is operated via charged battery. Charging
is done via the supplied power adapter.
• Direct power supply via power adapter is not possible.
• This rechargeable battery vacuum cleaner is no
adequate replacement for a conventional floor vacuum
cleaner. Especially on shag-pile carpet, the cleaning
performance is not sufficient owing to its design.
• Contaminated filters reduce the suction power of the vac-
uum cleaner. Therefore, we recommend regular cleaning
of the existing dirt filters.
• Ideally, clean the filters whenever they have been subject
to a prolonged use.
• Please regularly check and clean the electric floor
nozzle.
• If necessary, clean heavily soiled floors multiple times
and / or use a conventional 230 V~ floor vacuum cleaner.
Switching the Appliance On / Off
• The button (3) turns the appliance on and off.
• Press the ECO button on the back of the handset to tog-
gle between low and high power levels. In ECO mode,
you can extend the life cycle of the rechargeable battery.
The ECO button is illuminated.
Start-Up
Suction Pipe
• Insert the suction pipe with the two contact pins into
the connection on the hand appliance. It must audibly
engage.
• To disconnect the suction pipe, press the release PUSH
(16) and pull out the pipe at the same time.
Floor Nozzle with Turbo Brush
• Stick the lower end of the suction pipe onto the connec-
tor on the floor nozzle. Note the contact pins on the floor
nozzle. The suction pipe must audibly s snap into place.
• To disconnect the suction pipe, press the release PUSH
(14) and pull out the pipe at the same time.
• The floor nozzle is suitable for all floor coverings except
for shag-pile carpets.
47
05.06.19

Publicité

loading