hager TG550A Guide D'installation page 83

1. Introduction
1.1. How the detector works
The smoke detector is designed to protect the private areas of apartment buildings,
residential properties and mobile homes.
Smoke detection is especially suitable for detecting slow-starting fires that can
smoulder for many hours before catching alight.
It can be: • used alone,
• included in a hager alarm system with TwinBand
• interconnected in a wireless network with 40 detectors maximum.
When something is detected, this is indicated as follows:
Rapid flashing
Emergency halo lighting
Triggering of continuous sounding
(85 dB (A) at 3 m)
The detector having detected something sounds until the smoke have disappeared.
The interconnected detectors trigger in less than one minute and sound until the
smoke detected by the activated detector have disappeared and for a maximum
period of 15 minutes.
Subject to the smoke detector being properly serviced on a regular basis, it should
be replaced according to the replacement date indicated on the back of the
product or when its battery runs out.
Detector activated
control panel,
®
Other interconnected detectors
Emergency halo lighting
Triggering of intermittent sounding
(85 dB (A) at 3 m)
-
83