Ryobi P307 Manuel D'utilisation page 7

NOTE: For better control and consistency of application,
it is advisable to use two fingers to pull the trigger.
 When the desired amount of glue has been applied, re-
lease the trigger. Tilt the nozzle slightly to the side and
carefully pull the nozzle away from the object. This helps
avoid strings of glue clinging to the work.
NOTE: The glue gun will stop dispensing glue when the glue
stick in the chamber is almost used up. To refill the chamber,
set the glue gun down and insert another glue stick.
WARNING:
When servicing, use only identical replacement parts. Use
of any other parts could create a hazard or cause product
damage.
GENERAL MAINTENANCE
Avoid using solvents when cleaning plastic parts. Most plastics
are susceptible to damage from various types of commercial
solvents and may be damaged by their use. Use clean cloths
to remove dirt, dust, oil, grease, etc.
NOTE: ILLUSTRATIONS START ON PAGE 8 AFTER
OPERATION
MAINTENANCE
FRENCH AND SPANISH LANGUAGE SECTIONS.
 Always turn the on/off switch to the off position when you
are finished using the glue gun. Lift the drip tray located
underneath the glue gun to catch any glue drips while the
glue gun is cooling.
 Allow the glue stick and glue gun nozzle to completely
cool before removing the battery pack.
STORAGE
Allow the glue gun to cool completely before storing. Turn
the switch to the off position and remove the battery pack.
WARNING:
Always remove the battery pack before storage to ensure
the product is off. Allow a minimum of 30 minutes of cool-
down time before storage. Storing a glue gun with a hot
nozzle can cause serious burns and/or ignite combustible
objects.
To help prevent drips and clogs the next time the glue gun is
used, remove dried glue from the nozzle area.
7 — English