Ryobi P307 Manuel D'utilisation page 5

WARNING:
Do not use this product if it is not completely assembled
or if any parts appear to be missing or damaged. Use of
a product that is not properly and completely assembled
or with damaged or missing parts could result in serious
personal injury.
If any parts are damaged or missing, please call 1-800-525-2579 for assistance.
WARNING:
Do not allow familiarity with this product to make you
careless. Remember that a careless fraction of a second
is sufficient to inflict serious injury.
WARNING:
Always remove battery pack from the tool when you are
assembling parts, making adjustments, cleaning, or when
not in use. Removing battery pack will prevent accidental
starting that could cause serious personal injury.
WARNING:
Always wear eye protection with side shields marked to
comply with ANSI Z87.1. Failure to do so could result in
objects being thrown into your eyes and other possible
serious injuries.
WARNING:
Do not use any attachments or accessories not recom-
mended by the manufacturer of this product. The use of
attachments or accessories not recommended can result
in serious personal injury.
APPLICATIONS
You may use this product for the purposes listed below:
 Applying hot glue adhesive
WARNING:
Battery tools are always in operating condition. Place
the switch in the off position and remove the battery
pack when the product is not in use or when carrying
at your side.
ASSEMBLY
WARNING:
Do not attempt to modify this product or create accesso-
ries or attachments not recommended for use with this
product. Any such alteration or modification is misuse
and could result in a hazardous condition leading to
possible serious personal injury.
OPERATION
INSTALLING/REMOVING BATTERY PACK
See Figure 1, page 8.
 Make sure the high/low/off switch is in the off position.
 Insert the battery pack into the product as shown.
 Make sure the latches on each side of the battery pack
snap into place and that battery pack is secured in the
product before beginning operation.
 Depress the latches to remove the battery pack.
For complete charging instructions, see the operator's man-
uals for your battery pack and charger.
INSERTING GLUE STICKS
See Figures 2 - 5, pages 8 and 9.
The glue gun uses full size glue sticks - 1/2 in. (11-12 mm)
diameter. Use Ryobi glue sticks for best performance.
WARNING:
To reduce the risk of injury, the glue gun should be con-
sidered to be HOT whenever the LED on the unit is illu-
minated. Following this rule will reduce the risk of burns,
fire, or serious personal injury.
The LED indicator will illuminate red when the switch is turned
to the high or low position and the glue gun is warming up.
The LED indicator will illuminate green when the glue gun
has reached temperature and is ready to use.
 Make sure the high/low/off switch is in the off position.
 Insert a glue stick through the opening at the back of the
glue gun. Guide the glue stick into the glue chamber until
it will go no further.
 Lift the drip tray located underneath the glue gun to catch
any glue while the glue gun is heating.
 Install the battery pack.
 Move the high/low/off switch to the high or low position.
NOTE: In the high position, the glue gun warms up to
338°F (170°C). Low position is 266°F (130°C).
5 — English