Publicité
Les langues disponibles
Les langues disponibles
Charging the battery
WARNING:
supplied charger.
• Before first use, the battery must be
charged for at least 4 hours.
• Place the appliance on the wall mount bracket
(17) whenever it is not in use, as shown in
Figure A.
• Plug the jack plug of the charger into
the charging socket of the tool as shown
in Figure B. Plug the charger into any
standard 120 Volt 60 Hz electrical outlet.
WARNING:
to empty all contents and dry thoroughly if
needed to avoid damage to your appliance.
NOTE: While charging, the charger may
become warm. This is normal and does not
indicate a problem. The appliance can be
left connected to the charger indefinitely.
WARNING:
battery at ambient temperatures below 50 °F
or above 104 °F.
A
Switching on and off - Figure C
• To switch the appliance on, depress the
on/off button (1). The battery indicator
LED will illuminate and vacuum will begin
in the low-speed mode.
• Depress the button a second time to
engage the POWERBOOST mode. The
green LED will also illuminate, indicating
the vacuum is in the higher-speed mode.
• To switch the appliance off, depress the
button a third time.
For use only with the
Before charging, be sure
Do not charge the
B
C
POWERBOOST mode
The green LED will illuminate when the
appliance is in POWERBOOST mode. The
vacuum will operate at a higher suction level
to pick up debris that requires more power.
FILTERSENSE
Whenever a filter is blocked and needs
cleaning, the red LED in the handle will
illuminate. Clean dust from filter (See
"Cleaning the Dust Bowl and Filter" section).
Nozzle / Accessories
• A crevice tool (4) is built into the nozzle
(3). Extend the crevice tool as shown in
Figure D, until it clicks in place.
• To shorten the crevice tool, depress the
crevice tool release button (5) as shown
in Figure E and slide the crevice tool into
the nozzle.
• The brush tool (11) can be fitted into the
nozzle for dusting and upholstery cleaning.
D
E
4
Publicité
