Uspa UB-6235 Manuel D'instructions D'utilisation page 20

Connecting the water hose and grounding wire
Water tank
Trial operation
1. Preparation
Plug the power cord into the outlet. Press "BIDET" or "CLEANSING", then water tank will be filled within 2 minutes.After the
water tank has filled up, you will hear a long buzzer sound.
2. Checking all functions
Cover the toilet bowl using the plastic wrapping sheet of the unit to prevent water from being sprayed out of the toilet.
Then check for all the functions described in this manual.
3. During trial operation there are possibilities of remaining water coming out from the unit while
heating.
18
Close the shutoff valve by turning clockwise.
Flush the water tank completely to empty.
Disconnect the existing water supply hose from the shutoff valve.
Install the T-valve as shown on the picture.
Connect the existing water supply hose from the tank to the T-valve.
Connect the new flexible hose from the T-valve to the main appliance.
Open the shutoff valve by turning counter clockwise.
Check for any water leaking or dripping.
(1/2", 3/8")
T-valve
If the flexible hose is too long, it can be cut easily
to the required length.
Main unit
C
M
Y
CM
MY
CY
CMY
K