FAR DPW209W Mode D'emploi page 23

ENGLISH
USE
• This appliance is designed to operate in
ambient temperature between 16°C and 38°C.
If these temperatures are exceeded, i.e. colder
or warmer, the appliance will not operate
correctly. If the ambient temperatures are
exceeded for long periods, the temperature in
the freezer section will rise above -18°C and
food spoilage may occur.
• Remove all packaging materials from the
appliance. Wash the inside of the cabinet with
lukewarm water and bicarbonate of soda (5
ml to 0.5 liter of water). Dry the appliance
thoroughly.
• When you use the freezer for the first time
or after defrosting, set the thermostat control
to the maximum position for at least 2
hours before introducing food to be stored,
and then readjust to the normal position.
• If there is a power failure, do not open the
door. Frozen food should not be affected
if the failure lasts for less than 12 hours. If
the failure is longer, then the food should
be checked and either eaten immediately or
cooked and then re-frozen.
GB-8
SETTING THE THERMOSTAT KNOB
The refrigerator is controlled with a thermostat
knob located inside the fridge, towards the
upper right-hand corner. Turn the knob from
the STOP (OFF) position towards the higher
numbers for colder temperatures. The knob can
be adjusted from setting MIN, MED, MAX.
Higher settings on the knob (MAX) mean lower
temperatures (colder) in all compartments of the
appliance.
Changes of the ambient temperature affect
temperature in the interior of the appliance
so choose a correct setting of the temperature
control knob, depending on your ambient
conditions.
In the STOP (OFF) position the appliance does
not operate (the cooling system is switched off),
but power supply is not interrupted.
Set the thermostat knob to a middle position to
achieve -18 °C in the freezer compartment.
Please Note:
If the appliance is switched off you must wait at
least 5 minutes before restarting the appliance
ENGLISH
GB-9