Swann Xtreem SWIFI-XTRCAMW Guide De Démarrage Rapide page 6

The camera can be conveniently placed on a table or shelf, or mounted on the wall using the magnetic
stand (supplied) or the screw-in stand (optional accessory which can be purchased separately). Because
the camera is completely wire-free, you'll have a lot of flexibility on where you can put it. Choose a
location with strong, reliable Wi-Fi reception to ensure best video streaming and battery performance.
As a general rule, the nearer your camera is to your router, the better the wireless connection quality.
Mounting the magnetic stand
C. With double-sided mounting tape (For indoor use only)
Do not use on rough surfaces. Works best on smooth, dry surfaces (use rubbing alcohol
to clean surface, making sure it is cleared of any dirt).
Peel off liner on one side of the supplied mounting tape and apply it to the back of the
magnetic stand.
Peel off opposite liner then using a firm amount of pressure, press the magnetic stand
against the surface for 60 seconds. Allow 24 hours for the adhesive to fully cure before
EN
attaching the camera onto the magnetic stand.
6
CAMERA PLACEMENT
A. With screws (Recommended method
for permanent mounting)
Remove the rubber pads to reveal screw
holes. Then attach the magnetic stand to
the surface using supplied screws (2.8mm x
21.6mm) and plugs (if mounting on drywall
or concrete). Reinsert the rubber pads.
B. With keyhole slot
There is a keyhole slot on the
back of the magnetic stand
where a screw fits for hanging
on the wall. Insert screw (4mm
x 18.2mm) and plug (if mounting
on drywall or concrete) into the
mounting point, leaving a bit
of gap between the wall and
the screw head. Then fit the
magnetic stand over the screw
head through the keyhole slot
and slide down to make sure it
sits securely.
IMPORTANT: Ensure that the surface and fixing points
are strong enough to sustain the weight of the camera
and magnetic stand.