Publicité
Les langues disponibles
Les langues disponibles
SETTING THE TIMER
'
1
1,2
2,4
.3
6
u
The unit can be turned on at a specified time every day 'with the
built-in timer.
Preparation
Make sure the clock is set correctly,
Use the remote control.
1
2
3
Press the TIMER button while pressing the SHIFT
button once to display 0, and press the 11 SET
button within 4 seconds.
O
is displayed, and the hour flashes.
o
m'
If you press the 11 SET button after 4 seconds, another
operation may start.
Designate
the hour of the timer-on
time by
pressing the <
DOWN or _
UP button, and
press the 11 SET button. Repeat to designate the
minute of the timer-on time.
After you designate the timer-on time, one of the source name
flashes on the display for 4 seconds.
Within 4 seconds,
press the FUNCTION
button
repeatedly to select a source.
The selected source name flashes for 4 seconds.
If this step is not completed within 4 seconds, repeat from
step 1.
If the TUNER button is pressed, the band cannot be selected
in this step.
4
5
6
To listen to the ;adio, tune in to a station.
Press the POWER button to turn the unit off after
adjusting the volume and tone.
O
remains on the display after the power is turned off (timer
standby mode).
When the timer-on time is reached, the unit turns on and
begins play with the selected source.
The volume level is automatically set to 16 when the power is
turned off with the volume level set to 17 or more,
To check the specified time and source
Press the TIMER button while pressing the SHIFT button. The
timer-on time, the selected source name and the duration for
the timer-activated period are displayed for 4 seconds.
To cancel timer standby mode temporarily
Press the TIMER button repeatedly while pressing the SHIFT
button so that O disappears on the display.
To restore the timer standby mode, press again to display ~.
Using the unit while the tinner is set
You can use the unit normally after setting the timer.
Before turning off the power, carry out step 5 to prepare the
source, and adjust the volume and tone.
TIMER RECORDING
Timer recording is applicable for TUNER and VIDEO/AUX (with
an external timer) sources only.
Press the TIMER button repeatedly while pressing the SHIFT
button so that @ flashes on the display, and press the II
SET button within 4 seconds. Flepeat the steps shown above
from step 2 and insert the tape to be recorded into deck 2 after
step 5.
m
Timer playback and timer recording will not begin unless the
power is turned off.
Connected equipment cannot be turned on and off by the built-
in timer of this unit. Use an external timer.
ENGUS/-/
16
Publicité
