Invacare Aquatec Pure Manuel D'utilisation page 19

Perform automatic cleansing
The automatic cleansing function is a default function for people with
disabilities, children or the elderly, in which a complete cleansing
cycle is automatically executed.
1. Press AUTO button F on the remote control.
•
The 3rd level for water pressure, the 2nd level for warm
air dryer temperature and the last setting of nozzle position
are automatically set-up.
•
The Sensor forces to set the water- and seat temperature
to "Medium", in case the temperature were set up on the
"High" position.
•
A buzzer sounds when the auto cleansing function finishes.
2. Press STOP button B on the remote control.
•
The automatic cleansing process is interrupted.
Press AUTO button F again.
3.
•
The previous automatic cleansing process is resumed.
Automatic cleansing function: Move cleansing and warm air
dryer run for 1 minute each.
Setting water pressure
The water pressure can be set in three steps (indicated by first,
middle and last LED):
1590625-A
1. Press CLEANSING/MOVE button C on the remote control.
2. Press HIGH respectively LOW button J on the remote control.
•
The water pressure of the cleaning nozzle is raised or
lowered by one step and displayed on the LED A.
The last set value of the water pressure is automatically
saved by the device.
Setting nozzle position
Press FRONT respectively BACK button I during cleansing
1.
function on the remote control.
•
The cleansing nozzles move forwards respectively
backwards.
When the cleansing process is complete and you move away
from the seat, the nozzle moves back into the last setting
of the nozzle position.
Setting water temperature
The water temperature can be set in four steps:
Press WATER button H repeatedly on the remote control, until
1.
the desired temperature is reached.
•
The water temperature is displayed on the LED display
above.
Usage
19