Publicité
Les langues disponibles
Les langues disponibles
8200115-Modifs Notice CacG#D82D
Adjusting the humidity level
It is possible, even if the settings in this manual are respected, that you will
be unable to obtain the precise temperature/humidity desired. Each case is
individual and slight setting adjustments may be necessary.
Marks 1 & 2: Green lights go on when the compressor works to decrease the temperature.
Mark 3: Yellow light goes on when the fan works to increase the humidity level.
Mark 4: Red light goes on when the resistance coil warms up to increase the temperature level.
Instructions to increase humidity in your unit
The humidity level displayed on the screen is made to inform you (alarm when it
flashes) when there is not enough water to increase the humidity level to the
setting value. If you need to increase the humidity level then:
• Add 10 cl of water in each lava stone cassette only if the humidity alarm
flashes.
• Then, count the number of days between the first day you add water and
the day the humidity level will flash again (function of the surrounding tem-
perature and humidity levels of the room the humidor is installed in). That
will give you the period to add water again.
Instructions to decrease humidity in your unit
1 - If your unit can not decrease the humidity level, then:
• Empty your humidor, put the lava stone cassettes outside and clean them.
• Place the cap of the drain pipe as follows:
• Set the humidity level to 75 % but don't install the lava stone
cassettes or exchange them by new ones. Add water only if
the humidity alarm flashes.
2 - If this is still not enough to decrease the humidity level, then put the cap
of the drain pipe outside of your humidor.
3 - Contact your dealer if the problems are not corrected.
16/01/06
14:11
Page 8
page 8
4
3
1
2
Publicité
