Publicité
Les langues disponibles
Les langues disponibles
8200115-Modifs Notice CacG#D82D
Malfunctions
The compressor does not run.
The compressor never stops.
The thermometer inside your unit shows a temperature below the value you set.
The thermometer inside your unit shows a temperature above the value you set.
In the four cases above, if the malfunction persists even after changing the settings and
checking the indicator lights, contact your dealer.
Note: to assure that your Cigar humidor provides long-lasting service, you should
check it regularly and inform your dealer if you note anything unusual.
16/01/06
1 • Check the power supply by plugging in any electrical appliance.
2 • Change the temperature setting to a value below the indicated
temperature: after 5 minutes (safety delay) the green "cooling circuit"
light should come on.
3 • If the compressor still does not start: contact your dealer.
1 • Put a hand on the condenser (metal grid along the outer rear
wall of your unit). If the condenser is cold: contact your dealer.
2 • If the condenser is hot, change the temperature settings to a
value above that displayed: after 5 minutes (safety delay) the green
"cooling circuit" light should go out. If the compressor does not stop,
unplug the unit and contact your dealer.
1 • Verify the temperature settings from the information given on
page 7.
2 • Verify that the green "cooling circuit" light is out. If it is on, increase
the temperature setting. If the light still does not go out after 5 minutes,
contact your dealer.
1 • Check the temperature setting according to the information
given on page 7.
2 • Check that the green "cooling circuit" light is on. If it is not,
reduce the setting. If the light has still not come on after 5 minutes,
contact your dealer.
page 13
14:11
Page 13
Publicité
