Publicité
Les langues disponibles
Les langues disponibles
8200115-Modifs Notice CacG#D82D
Installing your
Cigar humidor
W
hen your unit has been delivered and unpacked, make
sure that there is no damage (such as might be caused by bumps,
etc.).
- Open the door and verify that the inside of your unit is in good
order (as regards walls, thermostats, shelves, hinges, etc.). If you
find any defects, please notify the carrier in writing.
- Then move your humidor to the location you have chosen for it.
This should be:
- in an open space, to allow air to circulate (not in a closed
cupboard, for example),
- at moderate temperature and well away fom any source of
heat,
- not too humid (such as a utility room, bathroom, etc...),
- on a firm, flat floor,
- be equipped with a plug (standard plug complying with
country standards with earth connection and differential
circuit-breaker).
- Unwind the power supply lead so that it can be accessed and
place the appliance so as to leave a space between 8 and 10 cm
between the wall and the back of the humidor.
16/01/06
14:11
page 4
Page 4
Publicité
