RIDGID WORK-N-HAUL IT AC9930 Mode D'emploi page 9

Other Portable Power Tools with
a Large Base
(Mounting holes in power
tool span 2 x 6 mounting blocks shown)
1. Place the stand in the set-up position
as shown.
2. Using the stand's table as a pattern, cut
two 2 x 6's to 24" length and locate as
shown. From the bottom of the stand
mark hole locations.
3. Drill 1/4" or 3/8" diameter holes in the
two 2 x 6 mounting blocks.
4. Temporarily attach the mounting blocks
to work stand with the supplied bolts or
1/4-20 bolts at least 2-1/2" long. Secure
with washers, lockwashers and nuts.
5. To attach your power tool locate and
drill holes in mounting blocks.
NOTE:
• A 5/8" diameter counterbore 1/4" deep is
required for clearance between the bolt
head and the work stand table. Tap car-
riage bolt with hammer to seat bolt fully
into the hole and counterbore.
• See views of bolt recommendations on
this page.
6. Remove mounting blocks from table.
Attach power tool to mounting blocks with
1/4-20 carriage bolts, washers, lock-
washers and nuts as shown. Reinstall
mounting blocks to work stand table.
Tools Needed for Assembly
Drill, 1/4" or 3/8" Drill Bit and
5/8" Wood Boring Bit
Hammer
See Bolt View A
See Bolt View B
Work
Stand
Bolt View A
(2 x 6's to Work Stand)
Power
Tool
Work
Stand
Bolt View B
(Power Tool to 2 x 6's)
9
7/16" Wrench
Set-Up Position
2 x 6
2 x 6