RIDGID WORK-N-HAUL IT AC9930 Mode D'emploi page 5

2. Slide lower foot into the stand assembly.
NOTE: A dimple has been placed on
one side of the work stand frame to aid
in proper assembly alignment of the
foot as shown.
3. Attach the lower foot on each side with
a hex bolt, curved washers, and a lock
nut as shown.
4. Firmly tighten the nuts with two M10
wrenches.
Moving the Carry Handle Spring
Pin
NOTE: Only ONE spring pin is required to
lock the legs in the set-up or knock-down
position. The spring pin can be assem-
bled on either side of the carry handle. To
change this location, follow the instruc-
tions below:
WARNING: When performing this
operation always wear safety goggles,
not glasses, complying with ANSI
Z87.1(or in Canada CSA Z94.3-99).
1. Note how the spring and washer are
assembled before relocating them to
the other side.
2. Hold washer and spring with thumb and
forefinger as shown.
3. Using a flat screwdriver pry the e-clip
off the groove in the end of the knob
shaft.
4. Reassemble the spring pin, washers
and spring to the other side. The knob
must be to the inside. Reassemble the
washer, spring and e-clip on the end of
the shaft away from the knob as shown.
Hex
Bolt
Dimple in
Frame
Tools Needed To Move Pin
Flat Screwdriver
Nylon
Washer
Knob
Knob
Nylon
Washer
5
Curved
Washer
Lock Nut
Goggles
Spring
Spring
E-Clip
Steel Washer