Publicité
Les langues disponibles
Les langues disponibles
AFTER SALES DEPARTMENT
ADDITIONAL USER MANUAL
Date : 23/06/2014
Version : 0
Page : 2 of 2
Subject: Temperature setting adjustment after controller replacement
Temperature setting adjustment:
Important: when the unit is working, and if you are not changing any settings, the value
shown on the display is always the actual temperature inside the cellar.
Press once
. SEt is displayed. Release
. Press once again
, the LED 1 is
blinking and the setting value is displayed (fixed).
Adjust the setting value with
or
.
Press once
to confirm the new value (SET is displayed quickly). The temperature
inside the cellar is displayed. The LED 1 is OFF.
Factory setting is 12°c.
The temperature can be adjusted between 9°c and 15°c.
When changing the temperature settings significantly, several hours may be
necessary to stabilize the temperature in the wine cellar.
Trouble symbols displayed:
Hit: displayed temperature higher than the upper temperature alarm.
Lot: displayed temperature lower than the lower temperature alarm.
PF1: the sensor input line 1 is opened (or disconnected) or short circuited.
EEP: memory error.
SAV-NT-0002-GB
Publicité
