Publicité
Les langues disponibles
Les langues disponibles
DO-230SR
TILE FLOORS
Use the concentrator with the detail brush attached to an extension. Have the floor
brush with cloth attached ready as well. Clean the grout between the tiles with the
detail brush. Remove the detail brush and attach the floor brush, move the brush
across the floor to clean the tile and remove excess moisture and residue. For areas
of tile that are very dirty, remove the towel and agitate with the brush. Do not let the
area dry before you wipe with a towel.
SPOT CLEANING (CARPETS)
Use the concentrator with or without the detail brush. Move slowly over the soiled
area, allowing the steam to penetrate. Agitate with detail brush or clean towel. Dab
the spot with the towel (do not rub). Repeat as necessary to remove stain. Vacuum
only after the carpet has completely dried.
Always test colour fastness of carpet in an inconspicuous area before cleaning. If
your steam cleaner fails to remove stubborn stains a commercially available carpet
shampoo may be required.
Do not add cleaning solutions, scented perfumes, oils or any other chemicals to the
water used in this appliance as this may damage the unit or make it unsafe for use.
UPHOLSTERY
Use the floor brush attached directly to the hand grip with a clean white terry cloth.
Use fast, light strokes to avoid getting the fabric wet. Be patient with stubborn spots.
Work on a spot gently for no more than a minute at a time, then wait five minutes
for the area to dry and repeat. Use circular movements or back-and-forth and side-to-
side movements to get all sides of the surface fibres then blot with a towel. Finish by
brushing in one direction to will give the fabric a uniform appearance.
Caution : always determine the colour-fastness on any fabric-especially with reds or
blues- by taking a clean, moist, hand towel and gently rubbing a small area as far
down on the back or other out of the way place on the furniture as possible. If colour
comes off on the towel, you may need to have the piece dry cleaned.
WINDOW, GLASS SURFACES AND MIRRORS
Use the dual edge glass and tile squeegee. Work with the vapor jet on using the top to
bottom movements. Use the squeegee with the vapor off to clean the water from the
glass. To do this without leaving streaks, use lateral movements from the top to the
bottom of the surface.
FIBERGLASS OR STAINLESS STEEL SURFACES
Use the floor brush or detail brush. Slowly move the brush over the surface to be
cleaned. The vapor will emulsify the dirt and grease on the surface. Follow behind
with a terry cloth towel over the brush to remove excess moisture and residue.
TIP : an old idea for polishing stainless steel is to wipe it down with seltzer soda
water after it is cleaned.
56
Publicité
