Bosch GTH 18V-38 M Professional Notice Originale page 21

Tacking – Contact Actuation
– Switch on the power tool.
– Activate the contact actuation by briefly pressing the
mode button (25).
The contact actuation display (27) lights up white.
– Press and hold the trigger (5).
The worklight switches on during this process and the
motor starts.
– Firmly position the outlet (15) or the rubber workpiece
protector (1) on the workpiece until the discharge lock-
Status indications
Status indicator for power tool (20)
Paint Meaning
Green Power tool is switched on and ready to use.
Yellow There is a problem that requires your attention:
Critical temperature, battery is almost empty or
service is due.
Red The power tool is not ready for use.
Reason: Power tool has overheated, battery is
empty or mechanical fault.
Flashing red – The second switch was pressed too early.
– The second switch was not pressed within five
seconds; the tool switches off automatically.
– The switches were pressed in the wrong order
(e.g. the trigger was pressed before the tool
had switched to contact actuation mode)
Battery charge indicator (21)
Symbol Paint
– –
Yellow
Red
Maintenance indicator
Symbol Paint
Yellow
Yellow
Press the reset button (24) to reset the maintenance
counter once the tool has been serviced.
Working Advice
Remove the battery from the power tool before carry-
u
ing out work on the power tool (e.g. maintenance,
changing tool, etc.). The battery should also be re-
Bosch Power Tools
off (2) is pressed down completely.
This discharges a staple.
– For another discharging procedure, keep the trigger (5)
pressed and completely lift the power tool from the work-
piece. Replace it firmly in the next required position.
– Switch to single actuation by pressing the mode
button (25) again.
The single actuation indicator (26) lights up.
User Interface (see figure B)
The user interface (9) is used to select the working mode
and to indicate the status of the power tool.
Solution
–
– Leave the power tool to cool down.
– Replace or charge the battery.
– Have maintenance performed.
– Leave the power tool to cool down.
– Replace or charge the battery.
– Have maintenance performed.
– Wait a short time until the status indicator dis-
– The power tool is ready for use again.
– Perform the discharging procedure again, ob-
State of charge
20–100%
1–20%
0–1%
Meaning
"Low" level routine service is due.
"High" level routine service is due.
moved for transport and storage. There is risk of injury
from unintentionally pressing the on/off switch.
Before starting work, always check that the safety and actu-
ation devices are functioning correctly and that all screws
and nuts are tightly seated.
If a power tool is defective or not functioning properly, dis-
connect it immediately from the power supply and contact
an authorised Bosch after-sales service centre. .
play lights up green.
serving the correct order of pressing when do-
ing so, or change the actuation mode via the
user interface.
Solution
Contact customer service.
Contact customer service.
1 609 92A 8UG | (22.11.2023)
English | 21