MILL Silent Pro Serie Manuel D'instructions page 14

12 12 12 millnorway.com
Maintenance free particle sensor
This unique sensor does not need any cleaning compared to traditional sensors. This will
avoid inflated particle values and a higher fan speed than necessary and will make sure
the air purifier works perfectly at any time.
True filter status indicator
Indicates when to change the filter based on the volume of particles measured, as op-
posed to a timer. This secures everyday filter efficiency and potential cost savings, as
the indicator will only tell you to change filter when it is actually dirty.
Icons
Child lock
Filter change status
Filter change status symbol
The filter change indicator will light up to remind you to change the filter.
NOTE! Symbol is always visible (when the display is lit) It shows the filter lifetime
remaining status with different colors.
White
Lifetime
remaining: 100-20%
Air quality light (IAQ)
The appliance has an air quality sensor that analyzes the air quality. The air quality light will
show the real-time air quality through different colors of light as shown below. By default
this table follows the particle values. You have the option of follow particles + TVOC or just
TVOC values in the Mill-app. Please note that the default settings may be adjusted in the
future.
Light color
Green
Cyan/Blue
Yellow
Red
Sleep mode
Timer
Yellow
Lifetime
remaining: 19-10%
PM1/PM 2.5/PM10
(μg/m3)
0–12
12,1–23,4
23,5–55,4
55,5–200+
IAQ & LED light brightness
Red
Lifetime
remaining: 9-1%
TVOC Air quality
0–65 Good indoor air quality
66–220 Moderate indoor air quality
221–660 Unhealthy indoor air quality
661–2200+ Very unhealthy indoor air quality
Blinking red
Lifetime
remaining: 0%