Ryobi WS721 Manuel D'utilisation page 7

If the saw is used with an extension cord, ensure the connec-
tion of the tool's power cord and the extension cord are not
on the ground. Auxiliary devices should always be plugged
into the wall outlet and not at the connection of an extension
cord and the power tools' power cord.
If a protected outlet is not available, do not use the saw
until an outlet can be changed or auxiliary protection can
be obtained. These auxiliary protection devices are available
at your local retailer.
POSITION OF THE TILE SAW
See Figure 2, page 13.
To avoid the possibility of the tool plug or outlet getting
wet, position tile saw to one side of a wall-mounted outlet
to prevent water from dripping onto the outlet or plug. The
operator should arrange a "drip loop" in the cord connecting
PRODUCT SPECIFICATIONS
Wheel Diameter ............................................................7 in.
Wheel Arbor .............................................................. 5/8 in.
Rip Capacity (tile size) ................................................16 in.
Diagonal Capacity (tile size) .......................................12 in.
KNOW yOUR TILE SAW
See Figure 3, page 13.
The safe use of this product requires an understanding of
the information on the tool and in this operator's manual as
well as a knowledge of the project you are attempting. Before
use of this product, familiarize yourself with all operating
features and safety rules.
7 in. TILE CUTTING WHEEL - A 7 in. tile cutting wheel is
included with your saw.
WARNING:
Do not use wheels rated less than the speed of this tool.
Failure to heed this warning could result in personal
injury.
BEVEL TABLE - Beveled 22.5° and 45° cuts can be made
using the bevel table.
HANDLES - Saw has convenient handles located on left
and right side for lifting and carrying.
ELECTRICAL
the saw to the outlet. The "drip loop" is that part of the cord
below the level of the outlet, or the connector if an extension
cord is used, to prevent water traveling along the cord and
coming in contact with the outlet.
If the plug or outlet does get wet, DO NOT unplug the cord.
Disconnect the fuse or circuit breaker that supplies power
to the tool then unplug and examine for the presence of
water in the outlet.
WARNING:
To reduce the risk of electrocution, keep all connections
dry and off the ground. Do not touch the plug with wet
hands.
FEATURES
Maximum Depth of Cut ......................................... 1-1/4 in.
Rating ..........................................120 V~, 60 Hz, 4.8 Amps
No Load Speed .....................................3,450 r/min. (RPM)
MITER GUIDE - The miter guide is fully adjustable for di-
agonal cuts and miter cuts.
MOTOR - This machine has a strong motor with sufficient
power to handle tough cutting jobs.
ON/OFF SWITCH - This saw has an easy access power
switch located below the front rail. To lock the switch in the
OFF position, remove the switch key from the switch. Place
the key in a location that is inaccessible to children and oth-
ers not qualified to use the tool.
RIP GUIDE - Rip guide is fully adjustable for making cross
cuts and using the miter guide.
SPLASH HOOD - The splash hood provides protection from
overspray and mist.
7 — English