Krups FNA241 Mode D'emploi page 12

• Your appliance is intended solely for
domestic and indoor use.
• Unplug your appliance as soon as you have
finished using it and when you clean it. Do
not unplug it by pulling on the cord.
• Do not use the appliance if it is not working
correctly, or if it has been damaged. If this
happens, please contact an approved KRUPS
service centre (see list in the service booklet).
• Any intervention other than normal cleaning
and maintenance by the customer must be
carried out by an approved KRUPS service
centre.
• Do not place the appliance, the power cord
or the plug in water or in any other liquid.
• Do not allow the cord to hang down within
reach of children.
• The power cord must not be close to or in
contact with the hot parts of your appliance,
close to a source of heat or resting on a
sharp edge.
• If the power cord or the plug are damaged,
do not use the appliance. To prevent any
risk, you must have these replaced by an
approved KRUPS service centre (see list in
the service booklet) .
• Do not place the appliance on a hot surface
such as a hotplate and never use it close to a
naked flame.
• For your own safety, please use only the
KRUPS accessories and spare parts which are
suitable for your appliance.
• Do not use the appliance when the drip tray
and the grille are not in place.
• All KRUPS appliances are subjected to strict
quality controls. Practical user tests are done
with appliances selected at random, which
explains any signs of use.
Before first use
It is recommended that you first rinse the
water heating system:
• Take the water tank (a) and fill it with cold
water (1).
• Replace the tank (a) by positioning it firmly
such that the connecting valve situated
beneath the tank opens.
12
• Plug in the appliance and set the switch (c)
to «I». The temperature indicator light (e)
flashes (green).
The capsule-holder head (f) must be closed
and empty.
• Place a fairly large container under the
coffee outlet.
Once the appliance reaches the correct
temperature, the temperature indicator light
(e) becomes fixed (green).
• Set the function selector (b) to the «
position and allow half the tank to run
through.
• When the container is full, set the function
selector (b) to the central position and empty
the container.
• Then place the container under the steam/
hot water nozzle (g). Turn the nozzle
outwards if necessary.
• Set the function selector (b) to the « »
position and allow the other half of the tank
to run through.
• When the container is full, set the function
selector (b) to the central position and empty
the container.
• If necessary repeat the operation until the
tank has been completely emptied.
• Reset the switch (c) to «0».
Using the various functions of
your appliance
. THE ESPRESSO FUNCTION
• Fill the tank (a) with fresh water (1) and set
the switch (c) to «I». The temperature
indicator light (e) flashes (green).
• Raise the handle (f1) to open the capsule-
holder head (f) (2).
• Place a NESPRESSO capsule on the holder
(f3) (3) (flat side down) and lower the
handle (f1) (2).
• Place a cup under the coffee outlet.
Once the appliance reaches the correct
temperature, the temperature indicator light
(e) becomes fixed (green).
• Set the function selector (b) to the «
position. The coffee starts to flow.
• You can stop the flow by returning the
function selector (b) to the central position.
»
»