Télécharger Imprimer la page

Pelgrim GVWC270L Notice D'utilisation page 164

Masquer les pouces Voir aussi pour GVWC270L:

Publicité

Les langues disponibles

Les langues disponibles

Troubleshooting
Error messages
F10
Overfilling water
F11
Water outlet fault
F12
Water inlet fault
F40
Inlet valve leakage
F41
Heater fault 1
F45
Diverter fault
F52
Water level fault
F54
Overfilling water
F56
Circulation pump fault
F67
Water inlet fault
F68
BLDC drain pump fault
Press any button to clear the error message.
General
Problem
The control panel does not react
when pressed.
28
Action
Unblocking the drainage pump. See the chapter Care and cleaning.
If the problem persists, contact your nearest service centre.
See "Water remains in the dishwasher" under "Problem" in the
table below. If the problem persists, contact your nearest service
centre.
Check that the water tap is on. Check that the outer filter on the
inlet hose is not blocked. See Unblocking the inlet hose filter in
the chapter Care and cleaning. If the problem persists, contact
your nearest service centre.
Turn off the water tap and contact your nearest service centre.
Turn off the water tap. Remove the plug from the wall socket and
contact your nearest service centre.
Contact your nearest service centre.
Clean the coarse and fine filters. Check that the outer filter on the
inlet hose is not blocked. If the problem persists, contact your
nearest service centre.
Turn off the water tap and contact your nearest service centre.
To avoid water leakage outside the dishwasher, do not remove
the plug from the wall socket until the water tap on the supply line
has been turned off!
Contact your nearest service centre.
Check that the water tap is on. Check that the outer filter on the
inlet hose is not blocked. See Unblocking the inlet hose filter in
the chapter Care and cleaning. If the problem persists, contact
your nearest service centre.
See "Water remains in the dishwasher" under "Problem" in the
table below. If the problem persists, contact your nearest service
centre.
Possible causes
You have pressed the control
panel too soon after opening the
door.
The door is closed.
Dirt on the control panel.
Action
Wait a moment then try again.
Open the door. The control
panel only reacts to use when
the door is open.
Clean with a dry or slightly
damp cloth.

Publicité

loading